A beautiful lawn with everything in its place and shaped perfectly. Sounds healthy enough for your OCD. But just like your health, the health of your beautiful lawn matters too.
Now the question is how can you ensure better health for your lawn. The solution is just a few adjustments with the mower deck of your lawn mower and regular care of the mower deck.
However, if you own a Husqvarna lawn tractor, then you’re in luck today. Because we’ll show you how to adjust mower deck on Husqvarna lawn tractor today.
We’ve got all the authentic info and well-organized steps that will guide you to a beautiful lawn. So, let’s slide into the details and get you started-
How to Adjust Mower Deck on Husqvarna Lawn Tractor
When someone says about adjusting the mower deck, it’s the adjustment of the height of the deck.
An uneven deck will mess up your lawn and make it look like that your lawn has been through a storm.
The tire and the leveled deck are the main concern when you’re mentioning the adjusting of the mower deck of a Husqvarna lawn tractor.
So, let’s check out the steps to your success right away-
Step 1: Park the Husqvarna Tractor
Park your tractor like you park your car, on level ground. Then you need to use the lever to raise the cutting deck to the highest position available.
And make sure that the ignition is off to prevent any accidents on the process. Also, don’t forget to remove the battery and spark plugs on the tractor. Let’s NOT get electrocuted today.
Step 2: Take the Ground to Bottom Measurement
You need to move to the front side of the deck and measure the distance from the ground to the bottom edge of the deck.
Also, keep in mind to do a measured check from the behind. Generally, it should be about 1/8th of an inch lower in the front.
Step 3: Loosen the Nut in Front of Adjustment Lever
Between the front wheels and in front of the mower deck, you’ll find the adjustment lever.
You’ll need to loosen the nut in front of each adjustment lever with a wrench. Use some force if it feels tight to move, don’t worry it won’t break.
Step 4: Adjust the Nut Inside the Bracket
There’s a nut inside of the bracket that you need to turn to raise or lower the cutting deck.
You need to turn the nuts on both sides equally, then tighten the front nut on each side, and re-measure the distance.
Step 5: Again Have a Ground to Bottom Measurement
Time to measure the distance between the ground and the bottom edge of the mower deck near the center and to one side. The distance of both sides should be exactly the same from the ground now.
Step 6: Work on the Link Adjustment Nut
Under the rear linkage on the last side measured, you’ll find the link adjustment nut there.
You need to adjust that nut as necessary until the two sides are even with each other.
Bottom Line
So, that’s how to adjust the mower deck on Husqvarna lawn tractor. Hopefully, we made it quite easy for you with this step-by-step guide.
However, be very careful when you’re dealing with this kind of mechanical vehicle that can cause you serious injuries.
Other than that, best of luck owning the most beautiful lawn ever.
